Madd Engineering Mount Kit (bmk.ef.001)
Basic Installation Instructions
Applications:
For installation of B16, B17, B18 or B20 engine, into 1988-1991 Honda
Civic/CRX.
Required mounts:
· Rear
Transmission Mount
· Side
Transmission Mount
· Side
Engine Mount
Installation Instructions: Pre-Swap
· Remove
hood and stock motor, as well as stock motor mounts.
· Create
an indentation on driver side chassis large enough for alternator pulley clearance
· Trim
or bend the rear cross member lip in, this is to obtain clearance for the B-series transmission mount.
· Install
the Side engine mount onto the block.
Swap Procedures:
· Install
the rear MT transmission L bracket onto the motor/transmission.
· Lift
the motor with an engine hoist and lower the engine into the bay.
· Line
up the rear mount with the Rear transmission mount provided in the kit.
· Insert
the bolt through the mount, do not torque the bolt down at this time.
· Install
the Side transmission mount onto the transmission.
· With
a floor jack or engine hoist, raise the motor/transmission to line up the Side transmission mount to the stock chassis mount.
· Insert
the bolt and do not torque bolt at this time.
· Line
up the Side engine mount (Driver side) with the chassis bracket.
· Insert
bolt, do not torque down at this time.
· Check
and make sure the motor is straight in relation to the chassis.
· Torque
all the bolts.
Intermediate Shaft:
· Use
any B-series shaft
Drive Shafts:
· Swap Shop drive shafts ba.ef.001
Call for pricing
Shift
Linkage:
· Madd Engineering shift linkage b.ef.001
IMPORTANT
In no event shall Swap Shop Racing. be liable for any direct,
indirect, special, incidental, or consequential damages-including loss
of profit-that may be claimed
as a result of failure of any part. Swap Shop Racing. assumes no responsibility, direct
or indirect,
for financial losses or claims from purchasers resulting from the use
of its products.
If you have any technical questions or installation difficulties,
please contact us (626) 914-3536